Make sure you have gas when you need it.

Dive Rite’s 200 bar manifold uses two barrel o-rings to seal either end of the cross-bar, providing better shock absorption than the old-style metal-to-metal seal manifolds. Our 200 bar manifold has a 180 mm isolation crossbar that fits both 7.25-inch and 8-inch diameter tanks and recessed burst disks are protected from accidental shearing. Shock absorbing ribbed rubber knobs are rugged, yet easy to manipulate. Dive Rite manifolds come standard for 3500 psi service pressure, with Viton o-rings and oxygen compatible lubricants and are Nitrox ready up to 40 percent. Can be used with both 200 bar and 300 bar regulators.

The Dive Rite Neck Clip Choker makes clipping the cylinders easier and causes it to lay tighter against your body, increasing streaming lining of your deco bottles, stage bottles, or sidemount bottles and reducing dangling and drag. Dive Rite Chokers For Neck Clip comes in a set of two.

Dive Rite valves are chrome-plated brass for rugged protection and durability. Double o-ring seals provide redundancy as well as better shock absorption. Ribbed rubber handwheels are tough, yet easy to open and close. The left valve paired with the right valve can be used for independent doubles, a doubles manifold, sidemount, and rebreather cylinders. The valve is modular so divers can use them independently on single tanks, put them together to form an H-valve, or use an isolation bar to build a manifold for double tanks. All Dive Rite valves come standard with 3500 psi (242 bar) working pressure relief disks, are built with oxygen compatible o-rings and lubricants, and are Nitrox ready up to 40 percent.

All Dive Rite valves are easily converted between DIN and yoke by using an included DIN to yoke insert. The insert is installed and removed with an 8 mm hex key.

Note: The Left Valve is the most commonly used valve for single-tank open water diving.

Dive Rite valves are chrome-plated brass for rugged protection and durability. Double o-ring seals provide redundancy as well as better shock absorption. Ribbed rubber handwheels are tough, yet easy to open and close. The right valve paired with the left can be used for independent doubles, a doubles manifold, sidemount, and rebreather cylinders. The valve is modular so divers can use them independently on single tanks, put them together to form an H-valve, or use an isolation bar to build a manifold for double tanks. All Dive Rite valves come standard with 3500 psi (242 bar) working pressure relief disks, built with oxygen compatible o-rings and lubricants, and are Nitrox ready up to 40 percent.

All Dive Rite valves are easily converted between DIN and yoke by using an included DIN to yoke insert. The insert is installed and removed with an 8 mm hex key.

The H adapter evolved from the Y valve. Originally produced by Sherwood in the 80s, the dual outlet Y valve for yoke regulators allowed divers to do limited overhead penetration while still having two independent regulator systems for redundancy. The H adapter is the latest generation of dual outlet single tank diving.

The H adapter screws into the crossbar outlet of the K valve so a second regulator can be attached for technical diving. The H adapter is available in 200 bar only and equipped with shock absorbing ribbed rubber knobs that are rugged, yet easy to manipulate. As an integrated part of the valve, no relief disks are necessary. All Dive Rite valves come with Viton o-rings and oxygen compatible lubricants and are Nitrox ready up to 40 percent.